tilting metal calf table design needed

[creatien]

Hi
I am chasing a design for a metal calf table. Some thing that I can make at the station as money is tight and we have a lot of metal pipe laying about.
I have looked on line and found the only plan for a metal drop but was hoping there are other designs out there . Any help would be welcome

Glenn

 

[cowgirl8]

What would you need this table for. Why would you need to tilt a calf?

 

[Hook]

What would you need this table for. Why would you need to tilt a calf?

It's easier to work a calf through a chute to a squeeze that rotates once the calf is caught up.

 

[cowgirl8]

I was just curious because of all the years working cattle, we've never needed to tilt a calf. Our full sized chute squeezes up calves at around 250 and up...

 

[Hook]

I've done it both ways. On calves up to 250, it is a back saver especially cutting bulls