Hondac
Well-known member
I'm having a bit of a problem with my JD 530 round baler. Basically, when the baler goes thru the
tying cycle and cuts the twine, the twine is too close the the edge of the bale. Then , when we
move the bale out of the field, the twine wants to fall off the end of the roll. I see no way to adjust this other than cutting the end of the feed tube off. Any ideas?
tying cycle and cuts the twine, the twine is too close the the edge of the bale. Then , when we
move the bale out of the field, the twine wants to fall off the end of the roll. I see no way to adjust this other than cutting the end of the feed tube off. Any ideas?