cornstalk
Well-known member
Hey all,
Recently picked up a new fuel sending unit for my 4020D from our local deere dealer. Removed the old, and installed the new. The previous gauge was stuck on E.
After installing the new sender. I turned the key on to find that the guage was now buried on F.
:?:
The tank is slightly under half per dowl stick. At first I assumed that I had put the sending unit in upside down. However, at slightly under half, I would be getting a reading of slightly over half.....if the unit was upside down. Anyone know....do these need to be calibrated somehow? Any ideas / insight ?
Thanks.
Recently picked up a new fuel sending unit for my 4020D from our local deere dealer. Removed the old, and installed the new. The previous gauge was stuck on E.
After installing the new sender. I turned the key on to find that the guage was now buried on F.
:?:
The tank is slightly under half per dowl stick. At first I assumed that I had put the sending unit in upside down. However, at slightly under half, I would be getting a reading of slightly over half.....if the unit was upside down. Anyone know....do these need to be calibrated somehow? Any ideas / insight ?
Thanks.