I've got spots like that! The bottom of the spade is right at gorund level, sometimes higher then that.denvermartinfarms":eakmhm6d said:I have done alot of it at 10 foot. but really 12 is what i do most of the time and it is fine. like dun said it depends on the terrain. just today we were going down the road in a very rocky area and i noticed a fence with t posts about every 8 foot and i pointed it out to dad and we decided it was most likely because they may have only been in the ground 5 or 6 inches.
I LIKE THAT 53 INCH PIPE TRICK I'll have to put that in my next stretch. No more wood for me in the runs either . I still use wood in my corners and such guess I'm too stuborn or too stupid to use pipe. Distance varies in the hills somtimes 6ft mostly 8 long . flat runs10 to 12ft depending on soil (don't holt real good in the bony chit) . :bang: :welcome:backhoeboogie":dfruvznr said:Haven't used a rope or string in years. Just set my pipe corners and braces then pull the third wire tight. Drive the t posts using the wire as a straight line. Push one in with the tractor, move the plastic pipe ten foot and push the next one. Have a pipe sleeve 53 inches long that slides over the T-Post being pushed in. Once the Post is in, slide the pipe off and go to the next one.
Haven't used wood since being burned out. Don't plan of using wood ever again. Can't afford to.
I use floating braces and only at corners or gates.Bestoutwest":2vrrr5bp said:How far do you go before putting in an h-brace?
Thanks
Animal Track Farm":3cnabmg3 said:I put in a H brace every 100 feet. I use T post in between spaced about 10' apart.
The method Jim shows is more complicated then mine but the principle is the same. I in mine rather then sawing the pocket in the postGunner":192dmupz said:Would someone explain a "floating brace" please.