Acceleration Explained

TexasBred

Well-known member
Joined
Aug 15, 2007
Messages
31,075
City & State/Province
Heart of Texas
Acceleration Explained

* One Top Fuel dragster outfitted with a 500 cubic-inch replica Dodge
(actually Keith Black, etc) Hemi engine makes more horsepower (8,000 HP)
than the first 4 rows at NASCAR's Daytona 500.

* Under full throttle, a dragster engine will consume 11.2 gallons of
nitro methane per second; a fully loaded Boeing 747 consumes jet fuel at
the same rate but with 25% less energy being produced.

* A stock Dodge Hemi V8 engine cannot produce enough power to merely drive
the dragster's supercharger.

* With 3000 CFM of air being rammed in by the supercharger on overdrive,
the fuel mixture is compressed into a near-solid form before ignition.
Cylinders run on the verge of hydraulic lockup at full throttle.

* At the stoichiometric 1.7:1 air/fuel mixture for nitro methane the flame
front temperature measures 7050 degrees F.

* Nitro methane burns yellow. The spectacular white flame seen above the
stacks at night is raw burning hydrogen, dissociated from atmospheric
water vapor by the searing exhaust gases.

* Dual magnetos supply 44 amps to each spark plug. Which is typically the
output of an electric arc welder in each cylinder.

* Spark plug electrodes are totally consumed during a pass. After 1/2 way
thru the run, the engine is 'dieseling' from compression and the glow of
the exhaust valves at 1400 degrees F. The engine can only be shut down by
cutting the fuel flow.

* If spark momentarily fails early in the run, unburned nitro builds up in
the affected cylinders and then explodes with enough sufficient force to
blow the cylinder heads off the block in pieces or split the block in
half!!

* Dragsters reach over 300 MPH +... before you have completed reading this
sentence.

* In order to exceed 300 MPH in 4.5 seconds, a dragster must accelerate an
average of over 4 G's. In order to reach 200 MPH well before reaching
half-track, at launch the acceleration approaches 8 G's.

* Top Fuel engines turn approximately 540 revolutions from light to light!

* Including the burnout, the engine must only survive 900 revolutions
under load.

* The redline is actually quite high at 9500 RPM.

* THE BOTTOM LINE: Assuming all the equipment is paid for, the pit crew is
working for free, & NOTHING BLOWS UP, each run will cost an estimated
$1,000 per second.

0 to 100 MPH in .8 seconds (the first 60 feet of the run)

0 to 200 MPH in 2.2 seconds (the first 350 feet of the run)

6 G-forces at the starting line (nothing accelerates faster on land)

6 negative G-forces upon deployment of twin 'chutes at 300 MPH

A NHRA Top Fuel Dragster accelerates quicker than any other land vehicle
on earth... quicker than a jet fighter plane...quicker than the space
shuttle....or snapping your fingers!!

The current Top Fuel dragster elapsed time record is 4.420 seconds for the
quarter-mile (2004, Doug Kalitta)

The top speed record is 337.58 MPH as measured over the last 66' of the
run (2005, Tony Schumacher)

Let's now put this all into perspective:

Imagine this...........You are driving a new $140,000 Lingenfelter
twin-turbo powered Corvette Z-06. Over a mile up the road, a Top Fuel
dragster is staged & ready to 'launch' down a quarter-mile strip as you
pass.
You have the advantage of a flying start. You run the Vette hard, on up
through
the gears and blast across the starting line & pass the dragster at an
honest
200 MPH. The 'tree' goes green for both of you at that exact moment.

The dragster departs & starts after you. You keep your foot buried hard to
the floor, and suddenly you hear an incredibly brutally screaming whine
that seares and pummels your eardrums & within a mere 3 seconds the
dragster effortlessly catches & passes you. He beats you to the finish
line, a quarter-mile away from where you just passed him. Think about it -
from a standing start, the dragster had spotted you 200 MPH.....and it not only
caught, but nearly blasted you off the planet when he passed you within a
mere 1320 foot long race!!!!


That, my friends.....is acceleration!
 
Top Fuel engines turn approximately 540 revolutions from light to light!

* Including the burnout, the engine must only survive 900 revolutions
under load.

Must be some pretty tall gears to get over 300 mph...............
 
alacattleman":2oxky4mj said:
peg4x4":2oxky4mj said:
Humm~yeah ~ speed~~ Why?
adrenalin rush, like the first time i rode in a 67 396 camaro as a kid, i got hooked :cowboy:

Mind was a in a 1956 ford with a 312 police interceptor in it. Bad to the bone.
 
As an Amazon Associate we earn from qualifying purchases. Product prices and availability are accurate as of the date/time indicated and are subject to change.
curtis":2g1sglu8 said:
alacattleman":2g1sglu8 said:
peg4x4":2g1sglu8 said:
Humm~yeah ~ speed~~ Why?
adrenalin rush, like the first time i rode in a 67 396 camaro as a kid, i got hooked :cowboy:

Mind was a in a 1956 ford with a 312 police interceptor in it. Bad to the bone.
im restoring my 69 ss 396 that i bought as teenager,,, hope too get it finished this coming year like this one ;-) http://www.bing.com/videos/watch/video/ ... B78790C5FC
 
Jim62":2gzh67ep said:
Top Fuel engines turn approximately 540 revolutions from light to light!

* Including the burnout, the engine must only survive 900 revolutions
under load.

Must be some pretty tall gears to get over 300 mph...............

That number looked strange to me until I remember that is revolutions per minute...so at about 7800 rpm's and running only 4.2 seconds that would be about right. Still hard to believe that kind of power and speed can come from an engine.
 

Latest posts

Back
Top