Ford 2810 Loader problem

Help Support CattleToday:

dcara

Well-known member
Joined
Jul 1, 2004
Messages
968
Reaction score
2
Location
East of Dallas Texas
87 model Ford 2810 with 7410 loader. 3 Point still works fine. Have already replaced filter and checked fluid level. Loader lift has gotten slower each time I use it for past 5 times or so and now has almost stopped lifting and rolling in. It still drops and rolls out/dumps. When I replaced filter I found a chewed up 1 inch long piece of red rubber about the size of a worm. Figured it was an o-ring from somewhere. But where. Should I just dive into the joystick?
 

wbvs58

Well-known member
Joined
Mar 20, 2011
Messages
5,880
Reaction score
1,015
Location
S.E. Queensland, Australia
On my older Kubota the suction line that goes in and out of the filter before going into the pump is only sealed by O rings. I just had to replace them recently as they were letting a bit of air in.

Ken
 

cfpinz

Well-known member
Joined
Sep 8, 2005
Messages
6,206
Reaction score
233
Location
Virginia
If the joystick supply comes from the rear remotes and they happen to be the deluxe style, make sure the aluminum cartridge inserts haven't started to unscrew and back out.
 

Latest posts

Top