Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Cattle Boards
Trucks, Tractors & Machinery
3 point spreader gear box
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="Little Joe" data-source="post: 1761830" data-attributes="member: 39122"><p>I just replaced the bearings and seals on a 3 point spreader, when I put it back together if I tighten all the bolts the shaft won't turn without channel locks. It will turn for a partial rotation then gets tight. I can loosen the bolts on either shaft end just a hair and it turns very easily by hand. I've taken it apart and put it back together several times and can't see a problem, I even put axle grease on the gears and the point where the shafs pivot inside the gear box. Any ideas?</p></blockquote><p></p>
[QUOTE="Little Joe, post: 1761830, member: 39122"] I just replaced the bearings and seals on a 3 point spreader, when I put it back together if I tighten all the bolts the shaft won't turn without channel locks. It will turn for a partial rotation then gets tight. I can loosen the bolts on either shaft end just a hair and it turns very easily by hand. I've taken it apart and put it back together several times and can't see a problem, I even put axle grease on the gears and the point where the shafs pivot inside the gear box. Any ideas? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cattle Boards
Trucks, Tractors & Machinery
3 point spreader gear box
Top