klm3030
Well-known member
Looks like a well made rig, should do the job. I am thinking along the lines of a 3 point hyd winder.
Any value to the used wire or just find the deepest ditch.Ol fence used to do it with just a piece of 2" pipe on a post hole digger. Cut a hole it the top to mount tot he auger and 4 or 5 other hole down the pipe to run the wire through. When finished, take the hole mess to the scrap yard.
This is what we use. I have rolled 4 wires at a time on it but shorter lengths.
It has scrap value. A lot of weight in miles of fenceAny value to the used wire or just find the deepest ditch.
i haven't done anything yet. Me and everyone else is waiting on funding from FSA and/or fence contractors. The fence contractors I have talked to already have similar machines so I might just let them do it.So how did it do ?
That would be no fun fencing or removing an old burn fence.Good ideas but they work on ground is lot flatter than a lot of what we are dealing with. I can go places with the quad that I wouldn't take a pickup or a tractor. There is a trail down to where that smoke is on the left side of the picture. But it is a little sketchy on a quad. Be suicide on a tractor or a pickup. The river is just the other side of the close up brush.
View attachment 49631
This is what we use. I have rolled 4 wires at a time on it but shorter lengths.
I believe it’s called LevelwindWhat brand is that?
Me too!I'd like to see that in action.
I like it. How does the bottom come off?I built this unit to go onto my post hole digger. Everything is from the scrap pile so all I have is some time and welding rod. Have rolled up a lot of wire with it usually 3 to 5 strands at a time.