Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Cattle Boards
Trucks, Tractors & Machinery
What brand/ply baler belts do you use?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="cfpinz" data-source="post: 1585034" data-attributes="member: 2383"><p>An inch or two off either side isn't a game changer, but if they get cut down too much you won't be able to make a full size bale. You're just guessing at this point, the only way to know what you have is to pull them and measure - at that point you can make an informed decision. On my old L (very similar to your baler) I had about 2' cut out of each belt and added a short section to get back to original length. Even with the springs set at 4-1/2", most of the time it wouldn't start turning until I fed a little hay into it. It didn't have a numerical pressure gauge on it, just red/yellow/green - so I can't tell you the exact pressure reading.</p></blockquote><p></p>
[QUOTE="cfpinz, post: 1585034, member: 2383"] An inch or two off either side isn't a game changer, but if they get cut down too much you won't be able to make a full size bale. You're just guessing at this point, the only way to know what you have is to pull them and measure - at that point you can make an informed decision. On my old L (very similar to your baler) I had about 2' cut out of each belt and added a short section to get back to original length. Even with the springs set at 4-1/2", most of the time it wouldn't start turning until I fed a little hay into it. It didn't have a numerical pressure gauge on it, just red/yellow/green - so I can't tell you the exact pressure reading. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cattle Boards
Trucks, Tractors & Machinery
What brand/ply baler belts do you use?
Top