Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Cattle Boards
Trucks, Tractors & Machinery
Vermeer 504 Super I Problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="True Grit Farms" data-source="post: 1581655" data-attributes="member: 24694"><p>Density pressure sounds really low, it thought around 1800+? 350 RPM is the sweet spot for my baler try going up to 540 and work your way down. Had a square baler that wouldn't bale or tie right if the pto was less than 500 RPM. With the baler off run the arms all the way out and make sure both are in time, if they are it's a line restriction problem.</p><p>What part of the world are you located in? One of the most knowledgeable Vermeer dealer is in Elko Georgia.</p></blockquote><p></p>
[QUOTE="True Grit Farms, post: 1581655, member: 24694"] Density pressure sounds really low, it thought around 1800+? 350 RPM is the sweet spot for my baler try going up to 540 and work your way down. Had a square baler that wouldn't bale or tie right if the pto was less than 500 RPM. With the baler off run the arms all the way out and make sure both are in time, if they are it's a line restriction problem. What part of the world are you located in? One of the most knowledgeable Vermeer dealer is in Elko Georgia. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cattle Boards
Trucks, Tractors & Machinery
Vermeer 504 Super I Problems
Top