Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Cattle Boards
Trucks, Tractors & Machinery
MF 255 Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="bgm" data-source="post: 763239" data-attributes="member: 1754"><p>I looked at my 255. It does not have the hole you mentioned. The operators and repair manuals only shows one zerk on each side. Most zerks are either 1/4-28 or 1/16 npt in inch sizes. I've not seen a press in zerk. I've seen press in oil ports, but I would think the pressure you can generate with a grease gun would push a press in zerk out too easily.</p><p></p><p>Hope this helps.</p><p></p><p>Good luck</p><p></p><p>Bryan</p></blockquote><p></p>
[QUOTE="bgm, post: 763239, member: 1754"] I looked at my 255. It does not have the hole you mentioned. The operators and repair manuals only shows one zerk on each side. Most zerks are either 1/4-28 or 1/16 npt in inch sizes. I've not seen a press in zerk. I've seen press in oil ports, but I would think the pressure you can generate with a grease gun would push a press in zerk out too easily. Hope this helps. Good luck Bryan [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cattle Boards
Trucks, Tractors & Machinery
MF 255 Question
Top