Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Cattle Boards
Trucks, Tractors & Machinery
Cutting torch problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="hurleyjd" data-source="post: 1519899" data-attributes="member: 4674"><p>Make sure the cutting tip is tight and not leaking any air around it. Also depending on tip size will determine the pressure setting. Acetylene pressure should be 3/5 psi and oxygen pressure around 20 psi. This is good up to about a three size tip.</p></blockquote><p></p>
[QUOTE="hurleyjd, post: 1519899, member: 4674"] Make sure the cutting tip is tight and not leaking any air around it. Also depending on tip size will determine the pressure setting. Acetylene pressure should be 3/5 psi and oxygen pressure around 20 psi. This is good up to about a three size tip. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cattle Boards
Trucks, Tractors & Machinery
Cutting torch problem
Top