Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Cattle Boards
Beginners Board
Barb spacing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="cmjust0" data-source="post: 235174" data-attributes="member: 2882"><p>I'm about to start putting up HT wire, and I'm planning to start at 9" off the ground and go 9" between all 6 wires.. That's 54" total. With "1" being the bottom wire, I was planning to electrify 1,3, and 6. I'm planning to isolate 1 from 3 and 6 with a floodgate controller so that if the weed load gets too high, it doesn't short the whole fence until I can take care of the situation. </p><p></p><p>I'm also planning to put a so-called "100-mile" low-impedance energizer on about 2 miles of fence, drive at least 3 ground rods in the runoff of the barn, and run *2* strands of HT wire from the box to the grounds.</p><p></p><p>And then I'm gonna buy about three bred cows, because that's about all I'll be able to afford once I get this rickafracken fence done. :lol:</p></blockquote><p></p>
[QUOTE="cmjust0, post: 235174, member: 2882"] I'm about to start putting up HT wire, and I'm planning to start at 9" off the ground and go 9" between all 6 wires.. That's 54" total. With "1" being the bottom wire, I was planning to electrify 1,3, and 6. I'm planning to isolate 1 from 3 and 6 with a floodgate controller so that if the weed load gets too high, it doesn't short the whole fence until I can take care of the situation. I'm also planning to put a so-called "100-mile" low-impedance energizer on about 2 miles of fence, drive at least 3 ground rods in the runoff of the barn, and run *2* strands of HT wire from the box to the grounds. And then I'm gonna buy about three bred cows, because that's about all I'll be able to afford once I get this rickafracken fence done. :lol: [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cattle Boards
Beginners Board
Barb spacing
Top