Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Non-Cattle Specific Topics
Tips 'n Tricks
woodworkers I need advice on joining some maple boards
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="Rafter S" data-source="post: 1709317" data-attributes="member: 21194"><p>If you hadn't already planed them down to thickness I'd suggest maybe screwing each end to a flat board and run both through the planer to get one flat surface, then take it off the straight edge, flip it over, and run it through again by itself, but now I got nothing. Sorry about that, and I wish you luck.</p></blockquote><p></p>
[QUOTE="Rafter S, post: 1709317, member: 21194"] If you hadn't already planed them down to thickness I'd suggest maybe screwing each end to a flat board and run both through the planer to get one flat surface, then take it off the straight edge, flip it over, and run it through again by itself, but now I got nothing. Sorry about that, and I wish you luck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Non-Cattle Specific Topics
Tips 'n Tricks
woodworkers I need advice on joining some maple boards
Top