Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Forums
Non-Cattle Specific Topics
Tips 'n Tricks
Say goodbye to carpenter bees
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support CattleToday:
Message
<blockquote data-quote="bbirder" data-source="post: 918689" data-attributes="member: 14490"><p>Slick, the entrance holes go in the side at about a 45 degree angle and enter the larger 1 inch hole in the center. What I did was get the drill started drilling straight into the board then once its bitten into the wood I turn the drill to a 45 while its running and push it in till you hit the 1" cavity.</p><p></p><p>But, do you angle down towards the jug, or up towards the ceiling?</p></blockquote><p></p>
[QUOTE="bbirder, post: 918689, member: 14490"] Slick, the entrance holes go in the side at about a 45 degree angle and enter the larger 1 inch hole in the center. What I did was get the drill started drilling straight into the board then once its bitten into the wood I turn the drill to a 45 while its running and push it in till you hit the 1" cavity. But, do you angle down towards the jug, or up towards the ceiling? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Non-Cattle Specific Topics
Tips 'n Tricks
Say goodbye to carpenter bees
Top