water tank

[Calman]

I think probably this was discussed before but we have since new members and besides i'm too lazy to look it up. But my question is,has anyone had any luck patching a hole in a rubbermaid water tank. One is not much bigger than a pencil and the other tank has a about a 3in crack in it.
I'd sure appreciate it if someone has patched these before and would share the info on how they got-er-done.

Cal

 

[dun]

JB Weld

 

[Running Arrow Bill]

Plastic, poly, or metal tank: Cut 2 pieces of rubber, one each side of hole, apply silicone, run a bolt through rubber. Works every time. Yes, JB Weld works also.