gildehbc":2rdi5t5m said:We are looking at some pull behind 300 gallon sprayers. Is anyone familiar with or had experience with the Heavybilt brand of spayers?? Or how about the pasture blaster form Ag -Spray??
gildehbc":2sfrq882 said:We are looking at some pull behind 300 gallon sprayers. Is anyone familiar with or had experience with the Heavybilt brand of spayers?? Or how about the pasture blaster form Ag -Spray??
40 years old and works just fine.. there's a reason it's an expensive pump, and that's the reason it's still working.. if you don't freeze them, they're virtually indestructable, they're made for wettable powders, etc, so all internals, valves, etc are ceramic and stainless.. Tank had a little bit of rust in it, but the lining has endured very well, I'll probably recoat it on the bottom.wbvs58":18bfw6w7 said:
Here's a vid of it.. if the link workswbvs58":kamkm4i1 said:
It's a little long to use on the Massey with the PTO extension, and a little short to use it without it.. it does have a slip yoke, but it's right about bottomed out there... I'll have to tune it to the tractor I want to use it on, when I decide on what that is.wbvs58":1sui6ux0 said:That's a nifty looking drive shaft on it too Nesi. I just can't make out how it expands though.
Ken
bird dog":1ospjitl said:I have had a heavy built about 7 or 8 years. 335 gallon low profile. I bought straight from the factory. Mine has been a good unit and I have pulled it over some real rough spots while fully loaded. The torsion axles are a nice feature. I looked at Wylies of the same type and thought the heavy built was just as nice for almost $1000 cheaper. I spray about 500 acres per year with it and also use the hand wand to spray brush.
The pumps are low end but not a big deal. Easily replaced for $120 or buy a rebuild kit for $40. I am on my third one.
They are good folks to work with and will help you out if you have a problem or need a part. I would buy another one.
Caustic Burno":2xg1760o said:gildehbc":2xg1760o said:We are looking at some pull behind 300 gallon sprayers. Is anyone familiar with or had experience with the Heavybilt brand of spayers?? Or how about the pasture blaster form Ag -Spray??
No most around here build there own
so much cheaper.
:lol2: optical illusion. couldn't come up with an easy and inexpensive breakaway solution so the boom folds back. I use bungee chords to hold them open. SMV emblem is on a bracket that holds them folded back.Brute 23":3hkwham6 said:Where did you get that huge triangle?
1982vett":19zqylxj said::lol2: optical illusion. couldn't come up with an easy and inexpensive breakaway solution so the boom folds back. I use bungee chords to hold them open. SMV emblem is on a bracket that holds them folded back.Brute 23":19zqylxj said:Where did you get that huge triangle?