Atimm693's latest activity

Anyone that spends enough time in one will put it on it's nose once or twice. After the first few times you'll develop a quick enough...

Takes half the toolbox to work on the stupid things, the engines have metric fasteners, but the chassis is all standard. Also plenty of...

No kidding. Even on our smooth ground I won't go much faster than 5mph.

2 hours? You running in road gear? I'm lucky to hit 60 acres in a day with a 20 footer.

That's correct, and drawbar heights between tractors vary quite a bit so it'll need to be adjusted for each one, assuming it's a pull...

Interesting. We've got an HX20 and an HX15, they both cut like a lawn mower and stripe well.

Can't go wrong with a Gator or a Mule.

For clipping pastures I'd say that's enough. If you're shredding thick brush and small trees, you'll want a lot more power. Also...

During one of the small ice storms we had this year, my Mom busted the door handle on her van. No biggie, ordered one on Ebay, swung by...

To add to all that, the Ford back up cameras can't be removed without breaking them. Smart engineering there. These new LED taillights...

I do know that the seals for ORB fittings are made of firmer rubber than standard O-rings. I ordered a bunch in common sizes a while back.

Go too far then you get into the "while you're in there" situation and end up rebuilding the whole thing. Manifold hardware and gaskets...

They typically recommend the first oil change at 50 hours or something after break in. You sure they're original or not just OEM...

I could see the use, but I could also see where it could lead you astray. I don't see that tool being able to put enough load on the...

I don't see anything glaring. PTO shield is a little banged up and it appears someone lost one of the lift arm pins at some point and...