

dun wrote:Either run additional hot wires or a rock drill and T-posts. Most of our area is the same way. When I built the bull pen on solid rock I used a hammer drill and punched holes a foot deep, 4-5 per post, and drove 5/8 rebar into the holes then poured a concrete footing a foot square and 6 inches above grade. Lots of work but it's held up with no problems


JSCATTLE wrote:dun wrote:Either run additional hot wires or a rock drill and T-posts. Most of our area is the same way. When I built the bull pen on solid rock I used a hammer drill and punched holes a foot deep, 4-5 per post, and drove 5/8 rebar into the holes then poured a concrete footing a foot square and 6 inches above grade. Lots of work but it's held up with no problems
In central Texas they use a rock drill and t post then pour a little sack creete around the post . I've hunted on places the fence went vertical for 100 feet . The fence builder repelled down the cliff to drill and set post according to the farmer .

kciD wrote:JSCATTLE wrote:dun wrote:Either run additional hot wires or a rock drill and T-posts. Most of our area is the same way. When I built the bull pen on solid rock I used a hammer drill and punched holes a foot deep, 4-5 per post, and drove 5/8 rebar into the holes then poured a concrete footing a foot square and 6 inches above grade. Lots of work but it's held up with no problems
In central Texas they use a rock drill and t post then pour a little sack creete around the post . I've hunted on places the fence went vertical for 100 feet . The fence builder repelled down the cliff to drill and set post according to the farmer .
if it's vertical- why even fence it in? I guess if you're keeping mountain goats out--- but last time I checked- cattle couldn't defy gravity...


dompeters84 wrote:I was thinking about using a drill to drill the rock but it just seems to time consuming. It may be my only option though.



Floyd wrote:Build some rock jacks. basically a crib for rocks. There are many types.


Return to Grasses, Pastures and Hay
Users browsing this forum: Google Adsense [Bot] and 6 guests